on ¾-inch carbon steel plate with a single bevel Preferred Qualifications • Previous pressure vessel or ASME fabrication...
procedures, and quality requirements Weld Test Requirements Candidates must successfully complete: • 20-inch Roll-Out MIG...
are required to pass two full penetration groove weld tests. This will be to a backing stripped, one inch thick, 45-degree groove in the...
. Assemble cable harnesses, chassis, 19-inch rack assemblies, test fixtures, and support equipment using engineering drawings...
to use the four arithmetic functions of add, subtract, multiply, and divide with money, measurements, e.g. cup, pint, inch...
. Essential Functions Investigates and resolves customer complaints regarding water meters (sizes 3/4-inch to 10-inch), water...
of Structural Welding Experience Required Certification: Current or Previous 2G Welding Certification Required Weld Test: 1-Inch... is required. Candidates must also successfully complete a 1-inch beveled groove fill-up weld test, including bend and cut testing. The ideal...
test using a MIG/Flux Core combination on 3/4-inch plate without run-off tabs. Ability to independently read blueprints...
and Flux Core processes. Candidates must successfully complete a 3G weld test on 1/2-inch plate using a downhill MIG stringer... complete: • 3G Position • 1/2-inch Plate • Downhill MIG Stringer • Uphill Flux Core Fill & Cap Candidates should arrive...
welding using .052-inch wire. Fabricate assemblies such as beams, columns, frames, supports, stairs, handrails, guardrails... welding using .052-inch wire. Fabricate assemblies such as beams, columns, frames, supports, stairs, handrails, guardrails...